The Aristocrat Line

Excellence In Communication Products

1. Align pre-drilled hole in accessory tray with pre-drilled hole in and insert the 4" carriage blot through the holes.   Install one wing nut but not tighten all the way (FIG. A).
2. Locate three upper legs (each leg has two pre-drilled holes) and align holes in top of legs (middle upper leg has two beveled cuts at top).  Insert 2½ carriage bolts through all three legs and install a wing nut.  Screw it on snugly but do not tighten (FIG. B).
3. Install two lower legs to the two front upper legs using two 1¾ machine screws and two wing nuts and tighten firmly (FIG. C.) Finger tighten only.
4. Install remaining lower leg to middle upper leg by inserting third carriage bolt through end of safety chain, into pre-drilled hole in lower leg, and tighten pre-drilled middle upper leg.  Firmly tighten third wing nut (FIG. C).  Finger tighten only.
5. Add accessory tray assembly to front leg assembly to tilting trays at approximately 1 45º angle and sliding one side of tray assembly onto one set of front legs.  Rotate the other side downward, sliding it on the other front leg assembly (FIG. D).
6. Holding trays firmly in position, remove wing nuts, insert loose end of safety chain onto machine screw and replace with wing nut (FIG. E).
7. Adjust trays to desired height and tighten wing nut firmly.  Finger tighten only.
8. Tighten all remaining wing nuts firmly. Finger tighten only.