|
PLEASE READ ENTIRE SHEET BEFORE ATTEMPTING SET-UP |
|
||
|
|
1. Fasten the top & bottom cones (A) to the 2 long legs as shown in Fig. 1. Use the Wrench provided. DO NOT OVER TIGHTEN THREADED NUT. 2. IMPORTANT - On 2 front legs near the bottom, the LARGE HOLE should be FACING INSIDE & THE SMALL HOLE should be FACING OUT. 3. Fasten the top & bottom Cross Bars (B) to the upright legs as shown in FIG. 2. Use 1 CURVED WASHER between the cone & leg as shown. |
||
 |
|||
|
|
4. When
assembling the Back Leg (C) use 2 CURVED WASHERS as shown in FIG. 3. One
on top & the other on bottom of the top cross bar.
5. The 2 Lower Picture Supports (D) are screwed into front legs using the 2 LONGEST SCREWS and the round Front Discs. 6. Assemble Chain (E) from the lower Cross Bar to the rear leg as shown. Put the EYE BOLT HEAD into the LARGER HOLE in the cross bar to let the screw come out the front longer and easier to put on the small. |
||
|
|
|||
